OmniSistem PR Headlight 2500 - Manual (Page 5)

5/8 Headlight 2500.manual.doc
Use the plug provided to connect the mains power to the projector paying attention to the voltage
and frequency marked on the panel of the projector. It is recommended that each projector is
supplied separately so that they may be individually switched on and off. It is recommended that
the projector connect to the mains using a 3-pin 32A plug.
TO ADJUST THE ANGLE OF TILT
You can adjust the angle of tilt from 0° to 40° by loosen the 2 locking knobs. In order to avoid that
the head turns over make sure that you hold the projector-head. After adjusting the desired angle
of tilt tighten the 2 locking knobs sufficiently.
TO ADJUST THE ANGLE OF PAN-MOVEMENT
The projector-head can rotate automatically at an angle of 110 degrees. And it can rotate at any
angles within 110 degrees by adjudting the knurling screw. Pressing the motor switch you can
stop the pan movement. Rotating the pan speed control you can adjust the speed of pan
movement.
With the reflector-bowl control you can adjust the rotation speed of the reflector-bow.
Pressing the motor switch you can stop the reflector-bowl rotating.
POWER SUPPLY - MAINS
ADJUSTING HEAD ANGLE
110
40 TILT
LOCKING KNOB FOR
ADJUSTING TILT ANGLE
PAN MOVEMENT
PAN SPEED
CONTROL
MOTOR SWITCH
KNURLING KNOB FOR ADJUSTING
ANGLE OF PAN MOVEMENT
REFLECTOR-BOW OPERATION
REFLECTOR-BOWL
ROTATIVE SPEED CONTROL
MOTOR SWITCH