OmniSistem PR Headlight 2500 - Manual (Page 2)

2/8 Headlight 2500.manual.doc
SECTION PAGE
SAFE USAGE OF THE PROJECTOR 3
TECHNICAL DATA 4
CONSTRUCTION 4
FITTING THE LAMP 4
POWER SUPPLY – MAINS 5
ADJUSTING HEAD ANGLE 5
REFLECTOR-BOWL OPERATION 5
MAINTENANCE 6
KEEPING THE PROJECTOR CLEAN 6
TROUBLESHOOTING 6
ELECTRICAL DIAGRAM 7
Please note that as part of our ongoing commitment to continuous product development, specifications are subject to change
without notice. Whilst every care is taken in the preparation of this manual we reserve the right to change specifications in the
course of product improvement. The publishers cannot be held responsible for the accuracy of the information herein, or any
consequence arising from them.
Every apparatus has been tested completely and packed properly by the manufacturer. Please make sure the packing and / or
the apparatus is in good condition before your installation and use. Should there be any damage caused by transportation,
consult your dealer and do not use the apparatus. But any damage caused by improper use will not be assumed by the
manufacturer and / or dealer.
THESE ITEMS ARE PACKED TOGETHER WITH THE PROJECTOR
3-Pin power socket (1PCS)
Tool for screw (2PCS)
This manual (1 PCS)
Thank you for purchasing the product HEADLIGHT 2500, P-1448.
This product manual contains important information about the safe installation and use of this
projector. Please read and follow these instructions carefully and keep this manual in a safe place
for future reference.
The HEADLIGHT is an innovative projector with an elegant housing made from high quality
aluminiun-alloy with an epoxy paint finish and it complies to CE norms and standards. The
protection against dust and liquid is high, IP 33. The rotative reflector-bowl produces a spray of
31 white beams, and the light beams are bright and sharp which can be visible for up to 10
kilometres, and the various beam colours can be available with the customer’
s desire. The
projector has safety devices both of auto thermal cut off and lamp power cut off. When the
temperature exceeds the allowance value, the lamp will be switched off automatically, and the
lamp will be switched on automatically when the lamp cools to the allowance temperature value.
If you make a mistake operation to replace the lamp such as open the projector-head cover
without switching off the power, the lamp and relative fans will be stoped automatically to avoid
the light damaging your eyes and relative fans cutting your fingers. As described above, it is an
ideal luminaire to light up buildings, exhibitions or for artistic applications.
ACCESSORIES
INDEX
INTRODUCTION