OmniSistem PR Design 150 Pro - Manual (Page 9)

Design 150 PRO EN doc 9/26
Green: ON —— DMX signal OK or in the Master mode;
OFF —— No DMX signal;
Flash ——DMX error;
Blue: ON —— Power ON;
OFF —— Power OFF;
Orange: ON —— To set control panel;
OFF ——To stop set control panel ;
Red: ON —— Master/Slave mode enabled or in the Slave mode;
OFF ——Master/Slave mode disabled;
Without using a controller, setup options Master mode enabled, the projector will run in
Stand-Alone mode with automatic programmes. See the section on “Setup Options –
Projector Configuration” for full details of the available combinations.
The DMX start address can be setted discretionarily.
Without using a controller, many projectors can run synchronously in the Master/Slave mode
by linking them with each other. Connect the master’s output to the first slave’s input, and
connect the first slave’s output to the second slave’s input. The rest may be deduced by
analogy. Eventually connect the last slave’s output to a DMX terminator. The example as
shown below:
Select one projector as the master with setting options Master mode enabled but slaves.
Regard the other projectors as the slaves setting options Slave mode enabled and all DMX
start address “001”.
If the projectors work normally, the LED should like this: Master—Green LED always on.
Slave—Red LED always on.
STAND-ALONE MODE
MASTER/SLAVE MODE
LED INDICATION