OmniSistem LED Par 64 (4 Channel) - Manual (Page 3)

LED PAR 64 PRO - 4 CH. Manual 2010-01-01
FEATURES
POWER: 117V 60Hz
POWER CONSUMPTION: 18W
FUSE: 1A (5 x 20mm)
LED COUNT:
151 10mm LEDs
(51 Red, 49 Blue, 51 Green)
BEAM ANGLE:
20° - 30°
FEATURES:
DIMMER
STROBE
CONTROL:
DMX-512 (4 CHANNELS)
STAND ALONE (AUTO, SOUND ACTIVE)
DIMENSIONS:
12” x 10” x 9”
WEIGHT: 4 LBS
IMPORTANT SAFETY INFORMATION
• This unit is intended for indoor use only.
• Ensure the power source is of the correct voltage for this fixture. Connect power through a direct switch circuit,
NOT a dimmer or variable circuit source.
• Disconnect unit from power when not in use.
• Do not install or operate the device in harmful environment conditions.
(i.e. extreme heat, cold, moisture or dust)
• If the unit has been exposed to extreme environmental conditions or drastic temperature fluctuations,
ensure the unit is returned to room temperature before operating.
• Do not block fan or ventilation slots while operating unit.
• Maximum Ambient Temperature is 113° C (45° C). Do not operate unit at temperatures higher than this.
• Do not move the device while in operation.
• Do not aim smoke or bubble effects near unit.
• Do not operate the unit during thunderstorms.
• Disconnect power prior to replacing fuse, servicing or cleaning unit.
• Do not use solvents or abrasive cleaners to clean the unit. Use a damp cloth only.
• Modification(s) to the device or power cord will result in termination of the dealer/manufacturer’s warranty.
• Use safety cable for added security when installing the unit by the hanging bracket.
• Avoid direct eye contact with the light source.
• Do not connect this unit to a dimmer pack.
• The safest way to disconnect your power cord from main power is to grip cord end and detach from plug.
• Do not leave unit unattended while operating for extended periods of time or overnight.
• Contact the nearest dealer or service center for assistance with operating your unit. Unauthorized tampering
can cause additional damage. All units opened by an unauthorized user will not be covered under warranty.