OmniSistem Q Beam - Manual (Page 9)

Q-Beam Operations Manual – 22-100002-01 – Rev 1 – 12-17-1999
Page 9
Sequential/Random color mode:
Sequential Chase: Colors alternate at each aperture. Colors switch again when
wrapping around, i.e.: the first pass is red, green, red,
green; the second pass is green, red, green, red.
Random Chase: Colors are picked at random.
Fixed color mode: The next menu selection will allow the choice of either red
only, or green only.
Press Enter to set color mode.
Fixed Color Mode Only:
Fixed Color Mode
Red or Green
Use Up or Down to select mode, and then press Enter to set.
Save ->
Cancel ->
Select Up to save changes, Down to cancel changes.
Saving changes also saves chase speed – after setting desired chase speed, use the
menu system without changing other options to save speed for next power cycle.
Q-Beam will restart in the selected mode.
Maintenance and Service for the Q-Beam
CAUTION!! Maintenance of the Q-Beam can be hazardous if the proper procedures are
not followed. Take precautions to avoid exposure of any part of your body from laser
radiation. Do not wear rings, metal watchbands or anything else reflective while performing
maintenance or service on the Q-Beam. Avoid inserting any material into the beam path
while the laser is on. Keep all non-essential personnel out of the area while cleaning or
servicing the Q-Beam. Be sure to warn any remaining personnel of the hazards
associated with laser light exposure.
How often should maintenance take place? This depends on the environment and
frequency of use for your Q-Beam. Typical run time between servicing is approximately 12
months.
Field Service of the Q-Beam is to be done by certified service personnel only.
Certification is granted by PULSE only.
Once certified, the service person is expected to contact PULSE before any servicing
begins.