OmniSistem Q Beam - Manual (Page 4)

Q-Beam Operations Manual – 22-100002-01 – Rev 1 – 12-17-1999
Page 4
Unpacking and Connecting Your Q-Beam
•
The Q-Beam ships in a container designed to prevent shipping damage. Take the Q-
Beam out of the shipping container and place it on a table or other area that will allow
inspection of the unit.
•
Inspect the Q-Beam for any visible signs of damage. Make sure to check the LCD
panel as well as each beam aperture. If your Q-Beam appears damaged and or the
shipping materials appear damaged contact your dealer within 24 hours to initiate a
shipping claim. *
•
Connect DMX-512 cabling if desired, and set the two dipswitch settings for your
application. (Rear Panel)
•
Ensure your projection area is clear for initial tests.
•
The Q-Beam is now ready to be turned on. (Refer to the operation section.)
*PULSE recommends that the original shipping materials be saved. These materials
insure safe transport back to PULSE for upgrades or service.
Shipping your projector without the yoke attached
or the factory packing materials will void the
warranty and may incur charges.