NORAC UC5-BC-SM02 - Manual (Page 19)

16
8 Module Installation
An optional module mounting bracket kit is available for purchase from NORAC. The
mounting brackets are compatible with control modules and input modules. One kit is needed
per module.
Item Part Number Name Quantity
B20 43708 UC5 MOUNTING BRACKET KIT (CONTROL AND INPUT MODULES) 1
8.1 Control Module
1. Refer to Figure 1 and Figure 14.
2. Securely mount the control module (E01) in the cab or on the sprayer, using screws, cable
ties or optional brackets. Refer to the display kit installation manual to determine the best
mounting location.
3. Connect the display terminal to the control module using the display CANbus cable. This
cable must be connected to the end of the control module with only one Deutsch
connector.
4. Connect the power cable (C30) to one of the two CANbus connectors on the control
module. Connect the other end of the power cable to an appropriate power source.
5. Route cable C06 from the other CANbus connector to the 2-way coupler (E12). Connect
cable C01 to the other side of the 2-way coupler.
6. The 2-way coupler (E12) should be located near the hitch to act as a hitch disconnect if the
control module is mounted on the tractor. If the control module is mounted on the
sprayer, E12 and C06 may not be required.
Figure 14: Control Module Mounting