NORAC UC5-BC-SC02 - Manual (Page 22)

18
8.3 Input Module
1. Install the input module (E03) on the boom near the sprayer valve block. Secure it to the
boom using cable ties or optional brackets.
2. Connect the free end of the CANbus cable (C02) from the valve module to the input
module.
3. Insert the 12 pin plug (P02) into the OEM 3 connector on the end of the input module
4. Connect the 12 pin connector on the tilt interface cable (C20) to the Thru 2 connector on
the side of the input module. Insert the other connectors on C20 into the tilt connectors
on the sprayer valve block.
Figure 20: Input Module Connections
5. Connect the 12 pin connector on the main lift interface cable (C21) to the Thru 1
connector on the side of the input module. Insert the other connectors on C21 into the
main lift and bypass connectors on the sprayer valve block.
6. The main lift valve on a Spra Coupe is located on the same valve block as the tilt functions.
The bypass valve is located on the rear of the rear axle, near the sprayer tank (Figure 21).
Figure 21: Spra Coupe Bypass Location
Bypass
Valve