NORAC UC5-BC-HD03 - Manual (Page 19)

16
6.5 Main Lift Sensor Installation
1. Drill a 3/8” hole in the end of the red mounting bracket (HD13) as shown in Figure 10.
Figure 10: Drilling the main lift sensor bracket
2. Mount the bracket onto the sprayer’s center section using the M6 bolt (HD10) and nut
(HD11).
3. Mount the sensor into the main lift mount as shown in Figure 11.
Figure 11: Main Lift Sensor Installed
Avoid mounting the main lift sensor over or near a wheel-track. Measurements
from the wheel-track do not provide an accurate crop height and will cause
measurement and control error.
Ensure the bracket does not collide with any other part of the sprayer throughout
the full range of main lift motion.