NORAC UC5-BC-GN05 - Manual (Page 19)

16
9 Connecting the Sensors to the CANbus
1. Route cable C03 from the input module to the 8-way coupler (E11).
2. Fasten the 8-way coupler to the boom with cable ties.
3. Connect both roll sensors (E04) to the 8-way coupler.
4. Connect two cables (C05) to the 8-way coupler and route along the booms to the wing
sensors. Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
Figure 15: UC5 Module Locations and Cable Connections
5. At the sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer boom.
The 2-way coupler with terminator is the white two way coupler. Plug the sensor and the
CANbus cable into the 2-way coupler.
6. Insert plugs (P03) into unused connectors on 8-way coupler.
Ensure that all unused connectors are plugged with the plugs provided.