NORAC UC5-BC-GN05 - Manual (Page 15)

12
7.2 Roll Sensor Mounting Guidelines
1. When mounting the roll sensors, mount the lowest serial number on the boom frame and
the highest serial number on the chassis (non-pivoting portion of the sprayer). For optimal
performance, minimize the distance between the roll sensors (A) and minimize the distance
from each roll sensor to the pivot point (B).
Figure 11: Roll Sensor Mounting
2. Ensure the roll sensors are relatively level when the sprayer boom and chassis are level.
3. Both roll sensor cables should be pointing towards the right hand wing of the sprayer.
4. Ensure both roll sensors are mounted adequately and that the cables provide enough slack
to allow sufficient boom roll.