NORAC UC5-BC-FC02 - Manual (Page 30)

27
10.3 Valve Block Mounting
1. Mount the valve block on the center section of the boom near the sprayer valve block, as
illustrated in Figure 26.
2. Insert the threaded rod into the block and use a hex nut to hold the rod. The block holes
are 3/8” NC-1” deep. If bolts are used instead of the threaded rod, ensure the bolts thread
in at least 3/8”.
3. Use the remaining hardware to secure the block to the sprayer.
4. Cut off excess threaded rod, if necessary.
Figure 26: Valve Block Mounting