NORAC UC5-BC-AP02 - Manual (Page 24)

21
8.3 Input Module
1. Install the input module (E03) on the boom near the sprayer valve block. Secure it to the
boom using cable ties or optional brackets.
2. Connect the free end of the CANbus cable (C02) from the valve module to the input
module.
3. Insert the 12 pin plug (P02) into the OEM 3 connector on the end of the input module
4. Connect the 12 pin connector on the tilt interface cable (C20) to the Thru 2 connector on
the side of the input module.
5. Insert the other connectors on C20 into the tilt connectors on the sprayer valve block.
Figure 24: Input Module Connections
6. Connect the 12 pin connector on the main lift interface cable (C21) to the Thru 1
connector on the side of the input module.
7. Insert the other connectors on C21 into the main lift connectors on the sprayer valve
block.
8. Connect the connectors marked AUX 1 together and the connectors marked AUX2
together.