NORAC UC4+BC+SM2 - Manual (Page 16)

13
4.5 R
OLL
S
ENSOR
I
NSTALLATION
Mount the roll sensors to the included roll
sensor brackets using the machine screws
and nylon lock nuts, as illustrated in Figure
11.
The roll sensors must be
mounted tightly to the brackets.
Figure 11: Mounting the Roll Sensor
to the Roll Sensor Mounting Bracket
When mounting the roll sensors, use the
following guidelines and refer to Figure 12.
a) The smaller the distance between A and
B in Figure 12, the better the
performance will be.
b) Ensure the roll sensors are sitting
relatively level when the sprayer chassis
and boom are level.
c) Both roll sensors must be mounted with
the circular AMP connector facing
towards the Right-Hand Wing (when
looking from the rear of the sprayer).
Figure 12: General Roll Sensor Mounting Location on a Trapeze Style Boom
Connectors towards
Right-hand Wing 