NORAC UC4+BC+HG1 - Manual (Page 15)

12
Figure 15: Roll Sensor Mounting with Respect to Sprayer Orientation
4.3.1 Boom Roll Sensor Mounting
The boom roll sensor is the roll sensor
with the temperature probe attached to it
(E03). To mount the boom roll sensor
refer to these guidelines.
1. The boom roll sensor must be attached
to the center part of the boom.
2. Use cable-ties to secure the bracket to a
square edge feature (square tube).
3. The AMP (circular) connector must be
pointing to the right hand wing (when
looking from the rear).
4. The ring terminal on the boom roll
sensor is a temperature probe and must
be attached to the side of the valve block
(Section 4.3.3).
Figure 16: Boom Roll Sensor Mounting Location
The roll sensors must
be mounted with the
Amp connectors
pointing to the right.