NORAC UC4+CS4-4B - Manual (Page 9)

7
7. If the valve block is not already installed
on the sprayer, install it as outlined in
the UC4+ Spray Height Control kit
installation manual.
8. Attach the straight 6FORX fittings on
the hoses (H02) to the A and B ports
on the expansion block. Route the free
end of the hoses (H02) to the Case
main lift tee, which is located near the
sprayer axle.
9. Disconnect the raise hose that runs
from the Case valve block to the main
lift tee and install the 6FORX 6MORT
(F03) onto the existing Case 6MORT
(Figure 4).
10. Connect the NORAC hose (H02) that
is connected to the B port on the
NORAC expansion block to the tee
fitting F03.
11. Reconnect the hose that runs from the
Case main lift valve block to the main lift
tee. This connects onto the tee fitting
F03.
12. Disconnect the lower hose that runs
from the Case valve block to the main
lift tee
13. Connect the NORAC hose (H02) that
is connected to the A port on the
NORAC expansion block to the tee
fitting F03.
14. Reconnect the hose that runs from the
Case main lift valve block to the main lift
tee. This connects onto the tee fitting
F03.
You must ensure no hydraulic
components will interfere with
any sprayer parts or be pulled
tight at any time.
Figure 4: Location of Main Lift Tees (When Looking From Front of Sprayer
towards the Rear)
Hoses running to
main lift cylinders
Main Lift Tee
connectors
Hoses running forward
to Case main lift block