NORAC UC4+CS4-4B - Manual (Page 11)

9
5
ELECTRICAL INSTALLATION
Figure 6: Cable Connections
Cable C16 and C17 are the only
cables included in the kit.
1. Locate the end of the previously
installed valve extension cable. This is
at the rear of the sprayer.
2. Disconnect the Case Interface Cable
from the Valve Extension Cable and
connect the 6-pin connectors on cable
C17 between the cables.
3. Connect the three pin shroud labeled
“Connect to C11” on cable C17 to the
free three pin tower on the valve
extension cable.
4. Connect cable C16 to the three pin
shroud on cable C17.
5. Connect the 2-pin connector on cable
C16 marked ROLL CCW to the coil
on the port side of the valve block.
The port side is the side of the
valve block with the left and right
tilt hoses.
6. Connect the 2-pin connector on cable
C16 marked ROLL CCW to the
other free coil.
The pigtails on cable C16 are not
used for this installation.
7. Tie up all cabling so that it will not
interfere with any components on the
sprayer.