NORAC UC4.5-BC-RG5 - Manual (Page 21)

18
6. Run cable C11 to the rear of the sprayer, in the vicinity of the valve block.
7. Connect the 6-pin shroud on C12 to T6 on C11.
8. Route the free end of C12 to the Rogator valve block.
9. Insert 2 sets of the Deutsch connector tees (which are labeled as “MAIN UP” and “MAIN
DOWN” on the branch wires) between the matching Rogator main control valve
connections: HOIST UP (MAIN UP), HOIST DN (MAIN DOWN). (Both “MAIN UP” tees
have the same functionality and can be matched to the HOIST UP connection.) One of the
“MAIN UP” tees will not be used.
10. Unplug the existing connectors on the Rogator left and right boom control valve
connections. There are 4 connectors to unplug: LH FOLD UP (LEFT UP), LH FOLD DN
(LEFT DOWN), RH FOLD UP (RIGHT UP) and RH FOLD DN (RIGHT DOWN).
11. Plug in the 2-pin Deutsch connectors of C12 to the matching connectors of Rogator
cable(s). For each connector, the function (e.g. “LEFT UP”, etc.) is labeled on the branch
wire of C12.
12. Connect the valve interface cable (C03) to connector S6 on the valve extension cable
(C11).
13. Connect the 2-pin connectors on the valve interface cable to the NORAC valve block, as
shown in Figure 18.
14. The connectors on the valve cable (C03) are marked RIGHT UP, LEFT UP, RIGHT
DOWN and LEFT DOWN. Cables labeled with UP go on the same side as the
hydraulic hoses.
Figure 18: Valve Cable Connections