NORAC UC4.5-BC-JD8A - Manual (Page 19)

17
6 Roll Sensor Installation
For this installation, the roll sensor is only being used for temperature
compensation.
1. Securely mount the roll sensors to the included roll sensor brackets using the #6 machine
screws. Tighten screws to 10 in-lbs (1.1 Nm).
Figure 12: Mounting Roll Sensor to Bracket
2. Attach the roll sensor and roll sensor bracket to the boom, near the NORAC valve block
using the provided cable ties.
3. Once the block is mounted, fasten the temperature probe from E03 to the NORAC valve
block using the included 3/8x1/2” bolt as illustrated in Figure 13.
Figure 13: NORAC Valve Block with Temperature Probe Installed