Char-Broil 463247512 - Manual (Page 15)

5
6
15
Upper back panel
1/4-20x1½”
screw
7mm lock
washer
7mm flat
washer
On back of grill, place upper back panel between side panels and above lower back panel.
Secure upper back panel, in lower holes, using one 1/4-20x1½” screw, 7mm lock washer, and 7mm flat washer on
each side.
Do not fully tighten screws until side shelf installation is complete in later steps.
Attach rear of shelf using one 1/4-20x3/4” screw, 7mm lock washer, 7mm
washer and 1/4”nut in upper hole; using one flat
1/4-20x1½” screw,7mm lock washer and 7mm flat washer in lower hole, shown B/C.
two Attach front of shelf and fascia using 1/4-20x3/4” screws, 7mm flat washers,
#8x3/8” self-tapping screw with large washer, shown C/D/E.
7mm lock washers and1/4”nuts, and one
Insert flange on right side shelf into side shelf brackets on side of firebox, shown A.
A
1/4-20x1½” screw
1/4-20x3/4” screw
7mm lock
washer
7mm lock
1/4”nut
1/4”nut
washer
7mm lock
washer
7mm flat
washer
7mm flat
washer
7mm flat
washer
Rear of Shelf
B
C
D
Note: Insert this screw from the back of
main control panel.
1/4-20x3/4”
screw
Back of main control panel
1/4-20x3/4”
screw
E
#8x3/8” tapping
screw
large flat
washer
7mm lock
washer
7mm flat washer
1/4”nut