National Cart SR-101 WRAPPING STATION - Manual (Page 6)

6
CLEANING THE UNIT
 Unplug the wrapping station before cleaning and/or servicing.
 When cut off bar and/or hot plate becomes dirty, clean with a cotton cloth.
Do not use metal or other abrasives. Do not immerse the wrapping station
in water or other liquids.
 Do not spray cleaners or liquids onto any electrical components.
SERVICING THE UNIT
 This wrapping station should only be serviced by trained personnel.
 Unplug the wrapping station before servicing.
 Do not attempt to repair or replace any parts other than the replacement
parts listed in these instructions. Improper repair or replacement may
result in electrical hazards
 Detailed instructions for replacement of the Cut off Bar and Hot Plate
Assembly will be sent along with the replacement part.
Fuse Replacement
1. Unplug the wrapping station before servicing.
2. Situate the wrapping station on a stable surface so that the back of wrapping
station is accessible.
3. Turn the fuse holder cap counter clockwise to loosen until it is released from the
fuse holder receptacle. The fuse will be attached to the cap.
4. Remove the fuse from the fuse holder cap by pulling gently.
5. Replace fuse with only with type 6D-1 amp fuse (part# 5000148).
6. Insert new fuse into fuse holder cap.
7. Insert fuse holder cap with fuse into the fuse cap receptacle.
8. Turn the fuse holder cap clockwise to tighten until it is hand tight.
9. Situate the wrapping station into normal operating position on a stable surface.
10. Plug the wrapping station in to a properly grounded outlet.