Compaq CP-2E - Manual (Page 73)

6–2 iPAQ Connection Point CP-2E User Guide
System Recovery
3. Follow the wizard directions.
Restore Factory Defaults
There are three ways to restore factory defaults:
> Use the firmware update procedure described above.
> Click the Reset Factory Defaults button on the System page of the
Advanced Setup tab. Refer to Chapter 6 for more information.
> Hold down the reset button on the back of the Connection Point
CP-2E for ten seconds. Refer to Chapter 1 for the location of the
reset button.
Each of these procedures restores all factory defaults to the Connection
Point CP-2E. Any configuration changes you have made will be lost.