Milwaukee Tool 2311-21 - Manual (Page 6)

6
momentary screen:
Momentary screens show the temporary button
layout for different functions. For example, the
select button becomes the shutter button when in
Picture mode.
Use the buttons to highlight
Momen-
tary Screen. Press the Select button.
Use the buttons to select “Always on”, “1 sec”
or “3 sec”.
Press the Select button to accept.
mic:
Use the buttons to highlight
Mic.
Press the Select button.
Use the buttons to turn microphone on or off.
Press the Select button to accept.
Version:
Use the buttons to highlight Version.
Press the Select button to display the software
version.
operaTion
Warning
To reduce the risk of injury,
wear safety goggles or glasses with side
shields. Always remove battery pack before
changing accessories or making adjustments.
Turning On/Off
Press the Power button to turn the tool on. Press
and hold the Power button to turn the tool off.
Sleep Mode
The tool will shut off automatically if unused for 5
minutes. To reset, press the Power button again.
Fuel Gauge
The fuel gauge is displayed in the lower right corner
of the LCD while the tool is on.
Full Battery Life 1/3 Battery Life
2/3 Battery Life Charge Battery
Warning
To reduce the risk of explo-
sion, electric shock and property damage,
always check the work area before begining
a job. Do not allow cable to contact electrical,
chemical, or moving hazards.
Behind walls: Shut off circuit breakers to the
entire area.
Inside Pipes: Ensure there is no electrical
charge to the pipes before beginning inspec-
tion. Do not allow liquid to flow down cable
and into tool.
Auto use: Turn off the engine and allow to cool
before beginning inspection. Do not allow the
visual inspection camera or cable to contact
oil, gas, or other corosive materials.
cauTion
To reduce the risk of damage to
the tool, do not use excesssive force or “kink”
the cable. Do not use in areas where visual
inspection camera and cable will contact cor-
rosive or oily substances.
Do not use the cable to clear clogs or move
obstructions. This is not a drain cleaner!
Picture/Movie Modes
Select the Picture or Movie mode button.
Adjust the cable to best fit the opening. After check-
ing the workspace for hazards, insert the cable.
Make any picture adjustments, as follows. Picture
Mode screens are used for examples:
led brightness
To increase or decrease
the brightness of the
camera LED, use the
buttons to select
Brightness . Use the
to increase and
decrease the brightness,
or turn the LED off.
Zoom
To zoom in or out, use
the buttons to select
Zoom . Use the
to zoom in and out.
rotate
To rotate the camera
view by 180°, use the
buttons to select
Rotate . Use the
to rotate the view.
Taking a picture
Press the Select
button to take a picture.
It is saved onto the memory card. The remaining
number of pictures that can be taken is displayed
in the lower left corner.
Taking a movie
Press the Select
button to start recording
a movie. Press the
Select button again
to stop the recording.
The movie is saved onto
the memory card. The
remaining recording time
is displayed in the lower left corner.
3664 3664 3664
00:43:54 00:43:54 00:43:54
3664 3664 3664
00:43:54 00:43:54 00:43:54
3664 3664 3664
00:43:54 00:43:54 00:43:54
3664 3664 3664
00:43:54 00:43:54 00:43:54