Milwaukee Tool 6580-20 - Manual (Page 5)

5
OPERATION
Fig. 3
Bit holder
Insert bit
Locator
Ramp-off
sleeve
Installing and Removing Bits
Drywall Ramp-Off Locator Assembly
Installing and Removing Magnetic Sockets on
Adjustable Screwdrivers
For Cat. No. 6580-20
1. Unplug tool.
2. To remove the magnetic socket, slide the locking
sleeve forward and pull out the socket.
3. To install the magnetic socket, slide the locking
sleeve forward and push in the socket until it is
fully seated.
For Cat. No. 6780-20
1. Unplug tool.
2. To remove the magnetic socket, slide the locking
sleeve forward and pull out the socket.
3. To install the magnetic socket, simply push in
the socket until it snaps into place.
Fig. 4
Locking sleeve
Socket
Fig. 5
Locking sleeve
Socket
WARNING
To reduce the risk of injury,
wear safety goggles or glasses with side
shields.
WARNING To reduce the risk of injury,
always unplug tool before attaching or remov-
ing accessories or making adjustments. Use
only specifi cally recommended accessories.
Others may be hazardous.
WARNING To reduce the risk of injury,
keep hands and cord away from the bit and
all moving parts.
Starting, Stopping and Controlling Speed
1. To start the tool, pull the trigger.
2. To stop the tool, release the trigger.
3. To vary the drilling speed, simply increase or
decrease pressure on the trigger. The further
the trigger is pulled, the greater the speed.
Locking Trigger
The lock button holds the trigger in the ON position
for continuous full speed use.
1. To lock the trigger, hold the lock button in while
pulling the trigger. Release the trigger.
2. To unlock the trigger, pull the trigger and release.
The lock button will pop out.
Using Forward/Reverse Switch
1. For forward (clockwise) rotation, push the for-
ward/reverse switch to the left position as shown.
2. For reverse (counterclockwise) rotation, push
the forward/reverse switch to the right position
as shown.
Although an interlock prevents reversing the tool
while the motor is running, allow it to come to a
full stop before reversing.
Fig. 6 Forward
Trigger
Reverse
Switch
Adjusting Locator Assembly
The locator assembly controls the tool's driving
depth. These screwdrivers feature a locator as-
sembly with one-handed depth adjustment. Depth
adjustments can be made easily and quickly by
turning the locator with one hand. Detents inside
the sleeve “lock” the selected depth.
For the drywall ramp-off locator assembly, start
with about 1/16" clearance between the head of
the screw and nose with the snap-action clutch
disengaged as shown.
1. Unplug tool. To remove the locator assembly, turn
the ramp-off sleeve while pulling it away from the
tool.
2. Push insert bit into bit holder until it snaps into
place. Push the bit holder into the nose of the
tool until it snaps into place.
3. Push the locator assembly onto the nose of the
tool until it snaps into place.