Milwaukee Tool 6742-20 Wiring 2011 - Manual

3
7
6
5
2
4 1
2
3
SINGLE REDUCTION PISTOL GRIP TOOLS
58-01-1801
DATE
June 2011
MILWAUKEE ELECTRIC TOOL CORP. 13135 WEST LISBON RD. BROOKFIELD, WIS.
BULLETIN
WIRING INSTRUCTIONS
TITLE
Drwg. 1
Terminals, Connectors and 1 or 2 End Wire Preparation
Wire
Color
Origin or
Gauge
Wire
No. Length
WIRING SPECIFICATIONS
BULK LEAD WIRE - BULLETIN NO. 58-01-0003
Grounding terminal
Green ground wire #3 connects
to male tab of grounding terminal.
Position terminal as shown.
(Grounded models only).
Route blue brush wire #6 and
white brush wire #5 through wire
traps over rear bearing bore as
shown.
FOR DOUBLE INSULATED TOOLS
DISREGARD GREEN GROUND WIRE #3
AND THE GROUNDING TERMINAL
Insert black wire #1
in the hole marked
2 on the bottom
of the switch
For grounded tools with
3-wire quik-lok cords, orientate
the pin housing assembly as
shown and place white wire #2
fi rst into the bottom of the handle
portion of the motor housing. For double insulated tools with
2-wire quik-lok cords,
orientate the blade housing as-
sembly as shown and place white
wire #2 fi rst into the bottom of the
handle portion of the motor hous-
ing.
In the main trap, route green ground wire #3 in
the bottom followed by the white wire #2 and
black wire #4 on the top.
Route black lead #4 through any of the three
traps on the tab of the motor housing and
insert into hole 2a on bottom of switch (Hole
is marked with a 2a on side of switch).
Route green ground wire #3 and
white wire #2 around the post in
the motor housing.
Post
Rear bearing bore
Fixed
cord shown
Black wire #1 Black wire #4
Bottom
view of
switch
1 Black * ----- *Component of cord set, pin hsg. assy. or blade hsg. assy.
2 White * ----- *Component of cord set, pin hsg. assy. or blade hsg. assy.
3 Green * -----
*Component of cord set, pin hsg. assy. or blade hsg. assy.
4 Black ** ----- **Component of the brush card assembly.
5 White ** ----- **Component of the brush card assembly.
6 Blue ** ----- **Component of the brush card assembly.
7 Brown ** ----- **Component of the brush card assembly.
Route green ground wire #3 and jumper wire (white) in
recessed area of brush card as shown.
.25 min.
SCHEMATIC
T2
T2
(T1)
TERMINAL DESCRIPTION
Part No. Code Qnty.
T1 23-74-0605 1
T2 23-74-1060 4
Jumper
Wire
7
6
5
4
1
2
4 1