Millennia LPE-2 Analog Legacy Phonographic / Archiving Preamplifier - Manual (Page 17)

17
LPE-2
PREAMP & SYSTEM SPECIFICATIONS
Input Amplifier Signal Path Discrete NPN Transistor/Hybrid (HV-3 PAM-01)
EQ Amplifier Signal Path All-discrete J-FET semiconductor (FSA-01)
Total Discrete Transistors (J-FET & NPN) Thirty six (36) in stereo audio path
THD + Noise, 20 Hz - 30 kHz
Less than <.01% typical, RIAA in, filters out
Frequency Response -3 dB points 3 Hz to 200 kHz, typical, flat
Frequency Response, +/- 0.5 dB 10 Hz to 100 kHz typical, flat
Common Mode Rejection Ratio -75 dBu typical, 10 Hz - 50 kHz, 1.0VPP C.M.
Maximum Input Level +23 dBu
Maximum Output Level +26 dBu
Maximum System Gain 60 dB Nominal. Higher on rqst. (Preamp + EQ)
Input Impedance User selectable (resistor/capacitor)
Factory Stock: 47.5k ohms & 270 pF
Output Impedance 49.9 ohms, unbalanced
Noise Better than -125 dB EIN, flat
Better than -98 dB EIN, RIAA in
Three-pin XLR Polarity Pin 2 = positive polarity, Pin 1 = ground
EQUALIZER SPECIFICATIONS
Maximum Filter Boost & Cut +/- 10 dB (21 step detent)
Notch Filter "Q" (Quality Factor) Q = 1.0
Low Frequency Comp Points 200, 250, 300, 400, 500/RIAA, 700/USER
High Frequency Comp Points (@ 10 kHz) -5.0, -7.0, -9.5, -11.5, -13.7/RIAA, -16.0/USER
Low Filter Fixed Frequencies 20, 35, 60, 100, 180, 260 Hz
High Filter Fixed Frequencies 1.0, 2.0, 3.0, 5.0, 8.0, 12.0 kHz
Peak/Shelf Selection on all Filters? Yes
Bypass Selection on all Bands? Yes
ELECTRO-MECHANICAL
Power Consumption 50 Watts, nominal
Power Requirements 100VAC to 240VAC, 50/60Hz, selectable
Fuses (2 required) 2 ea 1A with 100-120VAC mains (5x20mm,
slow-blow, 250V)
2 ea 500mA with 200-240V mains (5x20mm,
slow-blow, 250V)
Internal DC Power
+25V, -25V
Dimensions 19" W x 15.0" D x 3.5" H
Net Weight approximately 26 pounds
Millennia Media reserves the right to change specifications, delivery, and pricing without notice.