Millennia AD-D96 Series 5 - Manual (Page 2)

Millennia
Millennia Media, Inc. 4600 Missouri Flat Road Placerville, CA 95667
http://www.mil-media.com (530) 647-0750 Fax (530) 647-9921
Media & Music Systems
Access Jumpers by removing the cover
from the HV-3D. The digita;l board has
a diagram label showing the jumper
setting and locations similar to the
diagram on here.
FCC Notice Information for the User
– This equipment has been tested and
found to comply with the limits for a
Class A digital device, pursuant to part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
when the equipment is operated in a
commercial environment. This
equipment generates, uses, and can
radiate radio frequency energy and, if
not installed and used in accordance
with this instruction manual, may cause
harmful interference to radio
communications. Operation of this
equipment in a residential area is likely
to cause harmful interference in which
case the user will be required to correct
the interference at his or her own
expense.
DB25 Connectors conform to the Tascam pin out. Please note you can’t use
a pin to pin DB25 cable to connect the digital outputs to a DB25 digital input
connector. A special cross cable is required.
Tascam DB25 Wiring Charts
Clock Source SW2
Internal INT
External* EXT
Sample Rate kHz Rear Panel
44.1* X1 44
48 X1 48
88.2 X2 44
96 X2 48
Analog Input Channel 1 2 3 4 5 6 7 8
+ Pins 24 10 21 7 18 4 15 1
- Pins 12 23 9 20 6 17 3 14
Gnd Pins 25 11 22 8 19 5 16 2
AES DB25 Digital Inputs (not used) Digital Outputs
Channel 1/2 3/4 5/6 7/8 1/2 3/4 5/6 7/8
+ Pins 24 10 21 7 18 4 15 1
- Pins 12 23 9 20 6 17 3 14
Gnd Pins 25 11 22 8 19 5 16 2
*
*