Clock source – Millennia AD-596 User Manual
Page 2
Millennia Media, Inc.
4600 Missouri Flat Road
Placerville, CA 95667
http
(530) 647-0750
Fax (530) 647-9921
The Clock Source switch is accessible
without removing the cover.
Access Jumpers by removing the AD-
596 from the API rack and removing the
eight screws holding the cover on the
module
Caution. Make sure the
switch isn’t caught in the
opening when you remove
the cover. If you break the switch
off, the unit will be in External Clock
mode.
FCC Notice Information for the User
– This equipment has been tested and
found to comply with the limits for a
Class A digital device, pursuant to part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
when the equipment is operated in a
commercial environment. This
equipment generates, uses, and can
radiate radio frequency energy and, if
not installed and used in accordance
with this instruction manual, may cause
harmful interference to radio
communications. Operation of this
equipment in a residential area is likely
to cause harmful interference in which
case the user will be required to correct
the interference at his or her own
expense.
DB25 Connectors conform to the Tascam pin out. Please note you can’t use
a pin to pin DB25 cable to connect the digital outputs to a DB25 digital input
connector. A special cross cable is required.
Tascam DB25 Wiring Charts
Clock Source
SW2
Internal*
INT
External
EXT
Analog Input Channel
1
2
3
4
5
6
7
8
+ Pins
24 10 21
7
18
4
15
1
- Pins
12 23
9
20
6
17
3
14
Gnd Pins
25 11 22
8
19
5
16
2
AES DB25 Digital Inputs (not used)
Digital Outputs
Channel
1/2 3/4 5/6 7/8 1/2 3/4 5/6 7/8
+ Pins
24
10
21
7
18
4
15
1
- Pins
12
23
9
20
6
17
3
14
Gnd Pins
25
11
22
8
19
5
16
2
*
*