MF Digital SCRIBE 9000 Client User Manual
Page 2
Network Client Software
The Scribe comes with 100-base-T Ethernet. Gigabit Ethernet is also available at a
slight premium. This allows you to connect the Scribe as you would any Microsoft
Windows XP Scribe on your network. In doing so, you can share the Scribe with other
users on your network allowing them to submit jobs remotely.
Note: To obtain optional Scribe Client software, please click on the following link:
Client
Scribe
minimum requirements:
Client Scribe PC’s should meet or exceed these minimum requirements:
•
Pentium 4 or better processor
•
512 MB of RAM
•
Windows XP or Windows 2000
•
10GB of free NTFS formatted hard disk space.
•
If you use firewall software, be sure not to block the port(s) used by the
Scribe client software (virtual port 12345)
•
100 Base-T network supporting Microsoft TCP/IP protocol.
Installing the client software
The network client, a file named Client.exe, was copied to your hard drive during
installation. The client software is a single .EXE file and simply needs to be copied
to the desired location you can do either by copying the file to a server, a share on
the Scribe you wish to give client privileges too, or use the Scribe and write the
file to disc.
Here we will show you how to install and run from the desktop of the Windows
2000 / XP client Scribe.
•
On your Scribe, right
click on
Start and
select Explore.
•
Use
Windows
Explorer to browse
your
Scribe’s
hard
drive. If you have the
default
factory
installation, locate the
"C:\Program Files\MF
Digital\\” folder.
•
Right
click
on
client.exe and select
COPY.