Make Noise modDemix Classic - Manual (Page 3)

Installation:
The Make Noise modDemix is an analog electronic signal processor requiring 28mA of
+/-12V regulated power and properly formatted distribution receptacle to operate. It is
designed for use within the euro format modular synthesizer system.
Visit http://www.doepfer.de/a100_man/a100t_e.htm for the details of this format.
To install, find 6HP of space in your euro-rack synthesizer system, plug the 16pin power
cable into the euro-rack style power distribution board, minding the polarity so that the RED
stripe on the cable is oriented to the NEGATIVE12 volt supply line. This is USUALLY at the
bottom.
Please refer to your case manufacturers’ specifications for location of the negative supply.