Make Noise Brains - Manual (Page 3)

Installation:
The Make Noise Brains is an electronic signal generator requiring 20mA of +12V
regulated power and properly formatted distribution receptacle to operate. It is designed
to be used within the euro format modular synthesizer system.
Go to http://www.doepfer.de/a100_man/a100t_e.htm for the details of this format.
To install, find 4HP of space in your euro-rack synthesizer system, on the left side of the
Pressure Points to be expanded. Make all jumper settings on both BRAINS and the one or
two Pressure Points to be connected to BRAINS. Connect the EXPND cable between
BRAINS and Pressure Points number 1 (points 1-4). If there will be a second Pressure
Points, connect EXPND cable number 2 (points 5-8), and connect CHAIN cable between the
two Pressure Points. Now, plug the 16pin power cable into the euro-rack style power
distribution board, minding the polarity so that the RED stripe on the cable is oriented to the
NEGATIVE 12 volt supply line.
Please refer to your case manufacturers’ specifications for location of the negative supply.
Please see next page for further installation instructions.