Longshine LCS-PS112 - Manual (Page 78)

Reset Button
Reboot the Print server:
1. Verify the power of print server is turned on.
2. Press the reset button once, and then release it.
WARNING: This will restart the print server and stop all on-going and pending print jobs!
Perform a Factory Default:
1. Disconnect the external power adapter.
2. Hold down the reset button.
3. Reconnect the external reset button. Wait about 5~6 seconds.
4. Release the reset button.
5. The print server will restart.
WARNING: This will erase all settings of print server to default and should be performed with
caution!
After performing a factory default, the default settings will be:
DHCP client: off
IP address: 192.168.0.10
Subnet Mask: 255.255.255.0
78