Longshine LCS-GS8208-A V.1 - Manual (Page 17)

3.2.5 Qos
There are three modes of Quality of Service to choose, TOS, Tag Base, and Port
base. To Disable the QOS, click Disable and Click apply to save.
To use the TOS, select TOS and click Apply to save.
To enable the Tag Base, select Tag base and click Apply to save.
When you enable Port Base, packets from the port you select will have higher
priority.
To enable the Port base,
1. Select the port-base
2. Select the port-base ratio (1:4; 1:8; 1:16; Always High) The higher a ratio is,
the higher priority the port will get.
3. Select the ports in the table (High means high Priority, and Low means Low
priority). The priority depends on the Port Base rate.
4. Click apply to save
15