Longshine LCS-GS8208-A V.1 - Manual (Page 10)

3. Management guide
This section instructs you how to enter and set up the configurations, which can be
accessed by RS-232 serial port (out-of-band) on the rear panel or by Telnet session /
Internet Browser over the network (in-band).
.
Factory Default value:
IP 192.168.1.1
Subnet Mask 255.255.255.0
Default Gateway 192.168.1.254
3.1 Access the Switch
Console Port (Out-of-band) connection
The operating mode of the console port is:
DCE
9600 (Fix baud rate)
n (No parity checking)
8 (8 Data bits)
1 (1 stop bit)
None (No flow control)
After attaching a RS-232 cable (Straight-through) to the serial port of a PC
running a terminal emulation program, press “Enter” key then login screen
appears. Enter your username and password to login the management console.
Note
The management functions of console program are exactly the same with
web-based management interface but in text mode.
8
Attention 1. The factory default value of UserName and Password is
“admin”
2. System configurations via the Console Port only will be allowed
by the way of master device