beautypg.com

Lippert Components Ground Control 3.0 User Manual

Page 11

background image

Rev: 01.30.2015

Page 11

Ground Control 3.0 Service Manual

Component Replacement

NOTE: After replacing any of these components, you will need to "home" the jacks. See the corresponding

sections for instructions.

Landing Gear Replacement

1. Remove existing landing gear from the unit by removing the carriage bolts and nuts in the brackets

that are holding the landing gear in place.

2. Using the new carriage bolts and nuts, mount the new landing gear in the brackets so that the tabs

on the new landing gear are positioned between the mounting brackets as shown in Figs. 16 and 17.

Tighten the nuts on the carriage bolts until the bracket opening is less than 2 ½ ”.

3. Connect the wire harnesses to the landing gear motor wires and run the harnesses to the

compartment where the controller will be mounted.

NOTE: LCI recommends zip-tying the harnesses tight against the landing gear motors to prevent damage to

the harnesses.

Tab

Tab

Landing Gear

Fig. 16

Fig. 17

Main Frame Rail