Lippert Components Ground Control 3.0 User Manual

Page 5

Rev: 01.28.2015

Page 5

Ground Control 3.0 Owner's Manual

Auto Level

Auto Level Sequence

1. After unhitching from tow vehicle and parking the vehicle at a safe distance away from the unit, press

the “ON/OFF” button (Fig. 3A) and then press “AUTO LEVEL” (Fig. 3B).

Fig. 3

NOTE: Once the automatic leveling cycle has been started, it is important that there is no movement in the

coach until the unit has completed the leveling process. Failure to remain still during the leveling

cycle could have an effect on the performance of the leveling system.

NOTE: In order for hitch recognition feature to function, the auto level sequence MUST be started with the

front of the unit above level.

1. When Auto Level Sequence begins, the front of the unit will lower slightly to a point below level. The

coach will then stop and raise up to the point where it is level from front to rear.

2. Rear leveling jacks will be grounded.

3. A side to side leveling sequence will occur.
NOTE: At this point on the 6-point system, the two middle jacks will be grounded to stabilize the unit. These

two jacks do not level the unit.

4. Each jack will perform a final grounding touch.

5. LCD will read “AUTO LEVEL SUCCESS” (Fig. 4).

6. LCD will then read “READY Jacks: Down” (Fig. 5A), and the green LED at the center of the four jack

buttons will be illuminated (Fig. 5B).

Fig. 4

Fig. 5