Lippert Components Ground Control 2.0 - Manual (Page 4)

Rev: 04.10.2014
Page 4
Ground Control 2.0 Owners Manual FULL
Dropping off unit
1. Loosen J.T. Strong Arm Stabilizer “T” handles. (If applicable.)
2.
Disconnect 5th Wheel latch.
3. Turn battery power “ON.”
4. Release the inner legs of both landing gear jacks by pulling on the quick release pins and extending
the inner leg 4-5 inches.
5. Push touch panel “ON/OFF” (Fig. 2A) to turn system on. LCD Screen lights up (Fig.2B).
Fig. 1A Fig. 1B
6. Push the DOWN ARROW to scroll to “DROP FRONT JACKS” option on LCD screen.
NOTE: Orange arrow lights (Fig. 2C) may come on, indicating the current disposition of the unit. In this case
the FRONT and RIGHT sides of the unit are low.
7. Push “ENTER.” Both front landing gear jacks will go to ground and stop.
8. Push “FRONT” button to extend front landing gear jacks manually and lift front of vehicle to clear the
5th wheel hitch plate.
9. Pull tow vehicle away and park at a safe distance.
10. Release the inner legs of both rear leveling jacks by pulling on the quick release pins and extending the
inner leg 3-4 inches.
11. Push “AUTO LEVEL.” The unit will commence to auto level by setting the landing gear jacks close to
level. Rear-most jacks will extend to ground, followed by a second ground verification leveling jacks.
12. When auto level is complete, LCD indicates LEVEL SUCCESSFUL, Jacks: Down and the green light in
the middle of the jack buttons will light (Fig. 3A).
13. Tighten the J.T Strong Arm stabilizer “T” handles if applicable.
Fig. 2
C
A
B