Lippert Components Solera Slider - Manual (Page 3)

Rev: 09.05.2014
Page 3
Solera® Slider Install Manual
Prior to Installation
Tools Required:
• Electric screw gun
• 5/16" socket
• Square drill bit
• Butyl tape
• Tape measure
Additional Resources Required
• One extra person
Installation
1. Apply butyl tape to the flat side of the cord rail (Fig. 1A).
2. Place the cord rail parallel to, and centered above, the slide-out (Fig. 2).
NOTE: Cord rail should be a few inches higher than the fascia so that it creates a pitch for water and debris
to run off.
3. Fasten the cord rail to the coach with self-tapping screws every 8-10" (Fig. 2A).
Fig. 1
Fig. 2
A
A