Lippert Components Solera Power Awning with LED Lights OEM - Manual (Page 3)

Rev: 12.23.2014
Page 3
Solera Power Awning with LED Lights Install Manual
5. Take the LED tube power wire that is already fed through the idler leg and connect to the desired
power wire from the coach.
Note: Be sure black wire is to ground and white wire is to power source from coach.
Note: Extend and retract awning 1 or 2 times to ensure that it is square before setting the screws.
6. Attach awning cord to awning rail with two screws #6-20 x ½" Hex to prevent lateral movement.
7. Seal all wall penetrations to protect against water intrusion.
Note: All screws/rivets supporting awning assembly must have a backer within the structure of the wall of
the coach.
Note: Solera Awnings under 21' in length Do Not require the use of a center support or cradle.
LED Light Rail Installation
Note: Solera® Power Awning must be installed prior to LED Light Rail installation.
1. Mount the LED light rail track (Fig. 6B) directly below the awning cord rail (Fig. 6A) and secure to the
side of the trailer.
Fig. 6
A
B
2. Route the light wire over the top of the awning mount leg and run down through the leg in the same
manner as the motor wire (Fig. 7).
3. Cut wire to desired length and connect to the coach wiring, making sure to connect the red wire on
the light side to the power wire on the coach side.
4. Connect the black wire on the light to the ground on the coach side. The LED light rail must be wired
through a 5 amp (maximum) fused circuit.
Note: Make sure to seal the light track where it is screwed to the wall and also seal where light wire
connects to the coach wire.
5. Turn the light on to confirm that it illuminates.
Fig. 7