Lippert Components Solera User Manual
Page 2
Rev: 08.29.2014
Page 2
Solera® Power Awning Owner's Manual
Operation
Extending the Awning
1. Verify the battery is fully charged and connected to the electrical system.
2. Locate the locking latch (Fig. 1), if equipped, on the drive side awning arm and unlock the latch (Fig. 2).
NOTE: This latch is optional and may not be installed.
3. Press and hold EXTEND (Fig. 3A) until the awning is extended completely.
NOTE: Extension is considered complete when the awning valance seam reaches the leading edge of the
awning tube (Fig. 4).
Over extending the awning will roll the awning back up the wrong way and could damage the system
and will void the Limited Warranty.
Tying the roll bar down once extended will not allow the free floating support arms to work as designed
and may cause damage to the awning or RV.
TABLE OF CONTENTS
Operation
2
Extending the Awning
2
Adjusting Pitch
3
Fabric Care
3
Manual Override
4
Solera Power® Awning Assembly Webpage
5
Solera Power® Awning Components Webpage
6
Variant Code Information
6
Ordering Replacement Fabric
9
Fig. 3
Fig. 2
A
B
Fabric
Fabric
Tube
Valance
Fig. 1
Fig. 4