Levana Stella - Manual (Page 10)

DC Input
Note: Baby monitors and cameras with power cords should never be hung on or near the crib as it is a strangulation
hazard. Power cords should be kept no less than 3 feet away from the crib and the baby’s reach at all times.
Connecting Power to the Monitor / Charging Battery
1. Connect the small end of one power adapter into the DC input on the side of the monitor as
shown in the diagram. Connect the other end of the adapter into an available wall outlet.
2. Press and hold the POWER button on top of the monitor to turn the monitor ON.
3. The icon in the top right corner of the main screen will show you the battery power status.
4. The LED Ring on the front of the monitor also indicates the battery power status.
SOLID BLUE = BATTERY FULLY CHARGED SLOW FLASHING BLUE = BATTERY CHARGING
QUICK FLASHING BLUE = BATTERY LOW FLASHING PINK = PAIRING UNSUCCESSFUL
5. For safety reasons, ONLY use the adapters included in the package.
EMPTY CHARGING FULL
Connecting Power to the Camera
1. Take the second power adapter and connect the small end of the power adapter into
the DC input on the side of the camera base. For safety reasons, ONLY use the adapters
included in the package.
2. On the side of the camera, slide the POWER switch LEFT to the ON position. The
POWER LED will light up.
SETUP
LED Ring
ON / OFF
Switch
10 mylevana.com