Leslie Controls AFG-2, etc small flow airmate pressure reducing valve and air loader - Manual (Page 2)

2
INTRODUCTION
This Installation, Operation, and Maintenance Manual is
intended to be as complete and up to date as possible. It
covers installation, operation, and maintenance procedures
for Leslie Controls, Inc. Small Flow Airmate Pressure
Reducing Valves. Leslie reserves right to update this
manual and other product information concerning
installation, operation, and/or maintenance, at any time and
without obligation to notify product owners of such
changes.
Leslie is not responsible for injury to personnel or product
damage due to improper installation, operation, and/or
maintenance Leslie Controls, Inc. Small Flow Airmate
Pressure Reducing Valves. All installation, operation, and
maintenance procedures should only be performed by
trained/certified personnel. All personnel performing these
procedures should completely and carefully read and
understand all supplied materials before attempting
procedures. All personnel should pay strict attention to all
Notes, Cautions, and Warnings that appear within
procedures detailed in this manual.
Leslie welcomes user input as to suggestions for product or
manual improvement.
Contact Information
For information concerning warranties, or for questions
pertaining to installation,
Operation or maintenance of LESLIE products, contact:
LESLIE CONTROLS INC.
12501 Telecom Drive
Tampa, FL 33637
USA Phone: (813) 978-1000
USA Fax: (813) 978-0984
www.LESLIECONTROLS.com
To order replacement parts, contact LESLIE CONTROLS
at address listed above, or call toll free:
USA/Canada/Caribbean Phone: (800) 323-8366
Note: Please include model and serial number of unit for
which parts are being ordered. If ordering by phone, please
have this information readily available.
GENERAL NOTES AND WARNINGS
Notes:
•
If questions are not answered by this manual, or if
specific installation, operation, and/or maintenance
procedures are not clearly understood, contact
Leslie Controls, Inc. for clarification before
proceeding.
•
If unit is damaged during installation, operation, or
maintenance, complete following steps:
1. Turn off and lock out pneumatic supply to unit in
an approved manner.
2. Turn off all incoming valves.
3. Contact in-house maintenance personnel or Leslie
Controls, Inc. for instructions.
Note: Throughout this manual, warnings will be
denoted by BOXES
It is strongly recommended that this document be reviewed
before attempting any installation, operation, or
maintenance procedures.
CAUTION!
Piping system must be adequately designed and
supported to prevent extraordinary loads to pressure
equipment.