Controls and features, Ac power switch – to switch the unit power on/off, Rcd- trip switch safety device (test monthly) – LABEC SW-1 User Manual
Page 5: Operation instructions, Operating

create a fire or shock hazard.
7.
Always use the supplied handle to remove hot blocks to avoid
burning your hand.
2. Controls and Features_________________________
1.
UP Key – to increase temperature or time value
2.
DOWN Key – to decrease temperature or time value
3.
Heating – The OP1 LED light that indicates temperature is
increasing
4.
AC Power Switch – to switch the unit power On/Off
5.
RCD- Trip switch safety device (test monthly)
3.Operation Instructions________________________
Operating:
1.
Place the Warming Tray on a sturdy, level surface in a safe , dry place
away from laboratory traffic.
2.
Ensure that the AC power switch is OFF, then plug the three-pronged
power cord into a grounded three-prong AC outlet of the appropriate
voltage (240V as indicated on the rating sticker near the AC cord on
the back of the unit).
3.
Turn the AC power ON.
4.
Press the UP or DOWN key to adjust to desired temperature.
5.
Heating will begin automatically.
6. Set the Alarm overtemp AL4 value to prevent overheat to 5ºc above
set value “SV” in Level 2 (LVL2, using Code =2)
Laboratory Equipment Pty Ltd - Warming Tray 2014 Ver2.01 Instruction Manual
4