Warning, Read and carefully following manual instructions, Introduction – LABEC SW-1 User Manual
Page 4: Overview, Warnings

Warning:
1.
Read and carefully following manual instructions.
2.
Do not alter equipment. Failure to adhere to these
directions could result in personal and/or laboratory
hazards, as well as invalidating equipment warranty.
1. Introduction___________________________________
Overview
Labec Warming Trays use a Digital PID controller for easy
temperature selection, rapid heat up and excellent stability.
Temperature may be set in 1ºC increments from above ambient to
60ºC.
Warnings
1.
Use a properly grounded electrical outlet of correct voltage 240v and
current handling capacity.
2.
Disconnect from power supply before maintenance and servicing.
Refer servicing to qualified personnel.
3.
In the event solution is accidentally spilled into the bath, disconnect
grounded plug and turn incubator upside down to avoid solution
contacting the internal components. Remove bottom cover and
inspect to assure solution has not contacted elements, thermostat or
connector. Replace damaged parts.
4.
Do not use in the presence of flammable or combustible material; fire
or explosion may result. This device contains components, which
may ignite such materials.
5.
Refer servicing to qualified personnel.
6.
Ensure that the dry bath is connected to electrical service according to
local and national electrical codes. Failure to properly connect may
Laboratory Equipment Pty Ltd - Warming Tray 2014 Ver2.01 Instruction Manual
3