LABEC H-DW-HW50 - Manual (Page 10)

4
Defrost
●
Unused
●
Maintenance
①
There will be some frost on the surfaces of chamber for a long time running which may decrease the
performance of freezer. If the thickness of frost is more than 10mm, some defrost operations are
recommended.
②
Disconnect the power supply before defrosting. Wear special protective gloves for any interior
operation! Open the door and remove all materials from freezer. There are two ways to defrost: (I)
softly spud the frost on the surfaces with defrost shovel; (II) let the internal temperature rise naturally
to thaw all frost accretion. Then clean up the water thoroughly with dry rag.
③
Connect the power supply after defrost is completed to run your freezer.
④
Note：Any electric heater, metal tool or edge tool CAN NOT be used during defrost operation.
⑤
Leave Unused：If the unit is not used for long time, please disconnect power supply and maintain as
the following procedures. For next time operation, ensure there is no any water around the liners to
avoid the seal of door is frozen.
⑥
Clean: Regularly clean the filter for better performance of freezer. (Procedure: Loose the two bolts in
the ventilating panel and lay the panel flatly. Then loose the sit bolts in the filter and remove the dust
with soft brush or wash it. Dry the filter before installing again.
⑦
Maintenance：The freezer should be cleaned regularly. For personal safety, please cut the power
supply for any maintenance! Wear special protective gloves and glasses and wipe the inward and
outward walls with wet and soft rag.
⑧
Note：DO NOT sprinkle water on the faces of cabinets, which may decrease insulating property of
electric parts and rust metal parts.
DO NOT use hot water, corrosive cleanser and organic solvent!
Note：Prohibit minors or impaired persons using the freezer.