LABEC J-NBT - Manual (Page 7)

Operation Manual
J-NBT-M-E-09-001(REV.01)
P a g e 6
Safety Precautions
The following safety precautions must be observed and followed to avoid fire hazard, electrical shock,
accidents, and other failures. Keep them in mind and make sure that all the precautions are observed
and followed properly. Laboratory Equipment Pty Ltd assumes no liability or any responsibility against
any damages, accidents, or problems resulting from negligence by the users.
Users
! This product must be used only by qualified personnel who understand the
contents of this operation manual.
! If it is handled by disqualified personnel, personal injury may result. Be sure to
handle it under supervision of qualified personnel.
Purpose of use
! If the product is to be used for purposes not described in this manual, contact
LABEC in advance.
Input Power
! Use the product with the specified input power voltage.
! For applying power, use the AC power cable provided. The shape of the plug
differs according to the power voltage and areas. Use the cable which is suitable for
the line voltage used.
Fuse
! With products with a fuse holder on the exterior surface, the fuse can be replaced
with a new one.
! When replacing a fuse, use the one which has appropriate shape, ratings, and
specifications.
Cover
! There are parts inside the product which may cause physical hazards. Do not
remove the external cover. If the cover must be removed, contact LABEC in
advance.