beautypg.com

Danger – LAARS Mighty-Stack TL00-199 - Installation, Operation and Maintenance Instructions User Manual

Page 14

background image

LAARS HEATING SYSTEMS

Page 14

SECTION 2.

Operating Instructions

Water temperature over 125°F (52°C)
can cause severe burns instantly or
death from scalds.

Children, disabled and elderly are at
highest risk of being scalded.

See instruction manual before setting
temperature at heating appliance.

Feel water before bathing or
showering.

If this appliance is used to produce
water that could scald if too hot,
such as domestic hot water use,
adjust the outlet control (limit) or use
temperature limiting valves to obtain a
maximum water temperature of 125°F
(52°C).

WARNING

Should overheating occur or the gas supply fail to
shut off, turn off the manual gas control valve to the
appliance.

WARNING

Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to replace the appliance.

2A. Starting the System

1.

Close the manual gas valve located outside the
water heater. Turn on the power to the unit. The
pump should come on immediately. Check to be
sure that the pump is operating properly. If it
does not, test the electrical circuits.

2.

Before you open the gas supply valve, please
read the safety instructions at the end of this
section. These are very important. The burner in
this unit does not require manual lighting. The
pilot is controlled by a hot-surface proven-pilot
ignition system (see Figure 15).

3.

Open the gas supply valve. The pilot and main
burners will light automatically if the tank
aquastat is calling for heat.

4.

In general, set the aquastat to the lowest setting
which will produce water of an acceptable

DANGER

temperature. This will give the most efficient
operation of the water heater.

5.

Once the heater is running, check the appearance
of the burner flames (see Figure 14). The burners
are located behind a cover on the front of the unit
(see Figure 2.) If the flame has “sooting” tips,
check for debris near the orifices. If the orifices
are plugged, call a service technician to correct
the problem.

NOTE: Safe lighting and other performance

criteria were met with the gas manifold and control
assembly provided on the water heater when the unit
underwent the tests specified in ANSI Standard
Z21.10.3.

Figure 14. Flame Patterns.