Kuzma Stogi Reference - Manual (Page 14)

_________________________________________________________________
STOGI/STOGI REFERENCE 14 KUZMA
13. Securing Cartridge
The screws holding to the headshell must now be tightened and it is very important
to avoid moving the position of the cartridge, so tighten in the following way:
slowly, one screw at a time in extremely small stages. Before screws are
completely tight check that cartridge is still in alignment at position B and then
at position A.Then tighten screws firmly bearing in mind whether the cartridge
body is made of metal or plastic!
NOTE: If you find it impossible to align the cartridge, ie. the cartridge cannot move
far enough forward in the slots of the headshell, then the tonearm is incorrectly
positioned on the armboard, being too far from the record centre. If the cartridge
cannot be moved far enough back in the headshell, then the arm is too near the centre
of the record.
In either case the tonearm will have to be repositioned on the armboard. It should be
noted however, that different cartridges allow for more or less movement than others.