Kuzma Stogi Reference - Manual (Page 13)

_________________________________________________________________
STOGI/STOGI REFERENCE 13 KUZMA
Alignment at zero point 121 mm (B) Fig. 19)
7. Reposition protractor and check alignment at position B in the same vay as in position B.
8. If the cantilever is not in alignment then rotate protractor until it is in alignment
somewhere
along the line ‘x y’ though not necessarily at point B. (Fig. 20) Raise the cueing device.
9. If needle is in front of point B, pull the cartridge forward in the slots of the headshell for
approximately the same distance. If it is behind point B, push cartridge backwards for
distance ‘s’.
10. Now realign at point A as in 5 and 6 above ensuring that the position of the cartridge in
the
slots alongside is not changed.
11. Recheck alignment at point B. If cartridge is not aligned here rotate proractor to find
where on line ‘x y’ the cantilever is aligned. If it is in front as before, but nearer to point
B, then again pull cartridge slightly forward and repeat by aligning at point A. If stylus is
further forward on line ‘x y’ then move cartridge in opposite direction to before, ie.
backwards. (Fig. 20) If stylus is behind the B point, the cartridge should be pushed back.
Realign at point A and then at B.
12. Continue until stylus is in alignment at both points.
REMEMBER: a) align at B by rotation
b) check at B
c) align on line ‘x y’ and move cartridge.
Repeat a, b, c until cartridge is in alignment at both points.
NOTE: Ensure that cantilever is not twisted due to bias force.