Kuzma 4POINT 110630 - Manual (Page 6)

Fig.3 Protractor for pivot to spindle distance
Remove the fixing foam on the horizontal bearing assembly. Check that the bias thread is
fixed and gently rotate horizontal bearing assembly from one to another extreme. It is only
possible to make approximately ¼ of a turn. It is normal to feel slack in the bearings.
Tube assembly:
Carefully take the tube assembly with cable (there is also a heavy connection box) and gently
position it around the horizontal bearing assembly so that the two points will fit into the
appropriate bearing cups. Position it into the armrest.
(Fig. 2&4)
Remove cable from the tube assembly by releasing the black cable holder from the transport
position with the 1.5 mm Allen key. Fix it to the empty pin at the back of the VTA tower,
below the VTA locking lever. Fix it in such way, that the naked wires will go upwards
towards the tube in a loop. Be sure, that the VTA arm tower is fixed in the armbase, because
the weight of the cable might otherwise rotate it. (Fig.1)
3. Setting up the tonearm
Connecting tonearm:
Check the horizontal movement of the tube to ensure that the headshell will reach the inner
grooves (approximately to the edge of record label), but will not travel to the centre of the
record. Also check the arm wire loop and connect the tonearm cable into the phono sockets
of the preamp. (Fig.1)
You can add a second set of RCA cables into the termination box and connect this to a second
phono unit input. We do not recommend that both cables are connected to the same two input
of a single phono preamp. Disconnect one set. Secure the termination box using a Velcro
strip or long screws onto the turntable stand, somewhere to the rear.
Due to the high tonearm mass, turntable levelling and suspension should be checked and
adjusted according to the turntable manual.
6
264 mm